-1733801050.svg){kind=small}
RoutineMaintenance
Routinemaintenancekeepsyourbikerunningsmoothlywithregularoilchanges,fluidchecks,andfilterreplacements,allaimedatensuringpeakperformanceandreliability.
- Clean vehicle to remove dirt (WATER WASH).
- Check battery voltage and recharge if needed.
- Verify engine oil and replace oil/filter if required.
- Clean or replace air filter.
- Clean or replace fuel injectors if clogged.
- Inspect fuel lines for wear or leaks.
- Clean or replace spark plugs if worn.
- Adjust valve clearance if tappet noise is present.
- Check brakes and replace worn components.
- Adjust drive chain tension and clutch lever free play.
- Set engine idle speed to recommended RPM.
- Tighten fasteners to correct torque.
- Adjust tire pressure to recommended level.
- Wash vehicle to remove dirt (WATER WASH).
- Inspect and recharge the battery if needed.
- Check and change engine oil and filter.
- Clean or replace air filter.
- Clean or replace fuel injectors.
- Inspect fuel lines for leaks or damage.
- Clean or replace spark plugs.
- Adjust valve clearance if tappet noise is abnormal.
- Check brakes and replace worn components.
- Adjust drive chain tension.
- Check and adjust clutch lever free play.
- Set engine idle speed to recommended RPM.
- Tighten fasteners to specified torque.
- Adjust tire pressure to recommended PSI.
- Clean throttle and clutch cables.
- Clean and lubricate drive chain.
- Lubricate wheel bearings.
- Perform diagnostic check using Dscan/CFMOTO Pad.
- Foam wash to remove dirt.
- Adjust engine RPM.
- Replace or adjust brake pads.
- Replace accelerator cable if needed.
- Check and adjust tire air pressure.
- Inspect and charge battery if necessary.
- Test battery charging system.
- Clean or replace fuel injectors.
- Adjust engine valve clearance/tappet.
- Change engine oil and filter.
- Clean or replace air filter.
- Adjust or replace spark plugs.
- Tighten nuts and bolts.
- Adjust clutch or replace clutch cable.
- Adjust accelerator/throttle free play.
- Inspect/replace speedometer cable.
- Adjust or replace brake shoes.
- Lubricate pivot points.
- Clean and lubricate drive chain.
- Inspect/replace fuel lines if damaged.
- Overhaul front fork suspension.
- Check and refill brake fluid.
- Clean/replace throttle body.
- Perform FI & ABS diagnostic check.
- Replace front fork oil seals.
- Inspect and top up brake fluid.
- Clean throttle body for proper mix.
- Clear diagnostic trouble codes (DTC).
- Inspect/lubricate or replace steering bearings.
- Clean fuel tank to remove debris.
- Test and replace faulty sensors.
- Inspect and grease the swing arm.
